NCE0103M_NCEP065N10D Introduction

The power mos used on electric vehicles is a three-dimensional structure. Low-power mos is a planar structure. The mos tube we have seen is actually composed of thousands of small mos tubes in parallel. You may think that one or a few bad moss should easily appear in thousands of small mos. In fact, it is not that easy. , the current manufacturing process basically guarantees the high consistency of various parameters of these small units.

Xinjie, behind this FET NCE80H12, utilizes its own technical advantages to work closely with 8-inch wafer foundries, packaging and testing foundries, and has a complete quality management system to ensure continuous product quality and stable supply.

NCE0103M_NCEP065N10D

NCE3035G

As for why not to use depletion-type MOS tubes, it is not recommended to get to the bottom of it. For these two enhanced MOS tubes, NMOS is more commonly used. .

NCEB301G NCE3065G NCE30H14K NCE3095K NCE3065Q.

There is parasitic capacitance between the three pins of the MOS tube, which is not what we need, but is caused by the limitation of the manufacturing process.

NCE50TD120WT NCE40TD120T NCE40TD120BT NCE40TD120WT NCE40TD120LT.

NCE0103M_NCEP065N10D

NCEP0225G

NCE3416 NCE2010E NCE2006NE NCE8804 NCE8651Q.

NCE4612SP NCE30H32VD NCE3402 NCE3402A NCE30H21.

NCE6080K product features VDS=60V, ID =80A RDS(ON)<8.5mΩ@VGS=10V Ultra-low RDSON high-density battery design with good stability, good uniformity, high EAS and good heat dissipation packaging.

Applications ● Power switching applications ● Hard switching and high frequency circuits ● Uninterruptible power supplies.

NCE0103M_NCEP065N10D

The lithium battery is mainly composed of two blocks, the battery cell and the lithium battery protection board PCM.

The battery cell is equivalent to the heart of the lithium battery, and the lithium battery protection board is mainly composed of a protection chip (or management chip), a MOS tube, a resistor, a capacitor, and a PCB board.

relevant information