-
2022-09-23 18:12:25
NCEP0178F
NCE1450_NCEP0178F Introduction
In addition to the above-mentioned NCE80H12 suitable for electric vehicle controllers, Nanshan Electronics also provides Fenghua resistance-capacitance sense, long-crystal MOS transistors, Epson active and passive crystal oscillators, etc.
MOS tubes like NCE80H12 convert the DC power in the battery into AC power when the electric vehicle is running normally, thereby driving the motor to run.
NCE1450_NCEP0178F
NCE1570
NCE3404Y NCE3400A NCE3400 NCE30ND07AS NCE3008N.
. For these two enhanced MOS tubes, NMOS is more commonly used. As for why not to use depletion-type MOS tubes, it is not recommended to get to the bottom of it.
NCE3019AS NCE3045G NCE3400AY NCE30ND07S NCE8601B.
The reason is that the on-resistance is small and it is easy to manufacture. Therefore, in the application of switching power supply and motor drive, NMOS is generally used.
NCE1450_NCEP0178F
NCEP40T12AGU
NCE2060K NCE2090K NCE20H11K NCE20H18 NCE20H20.
When the applied forward voltage increases, the concentration of unbalanced minority carriers increases and the concentration gradient also increases, and when the applied voltage decreases, the change is opposite. Diffusion capacitance: When a forward voltage is applied, the non-equilibrium minority carrier concentration near the interface of the depletion layer is high, far from the non-equilibrium minority carrier concentration is low, and the concentration gradually decays from high to 0 until it reaches zero. The process of charge accumulation and release in this phenomenon is the same as that of capacitor charging and discharging, which is called diffusion capacitance.
Another technique is to intermittently improve the structure of the MOSFET and use a straight V-groove structure. FIG. 3 is a cross-sectional view of the structure of a V-channel MOSFET. In order to avoid the problems of too small current-carrying capacity and large on-resistance of MOSFET, two techniques are generally used in high-power MOSFETs. One is to connect millions of low-power MOSFET unit cells in parallel to improve the current-carrying capacity of MOSFET. .
. For example, electronic fuel injection system, anti-lock brake control, anti-skid control, traction control, electronically controlled suspension, electronically controlled automatic transmission, electronic power steering, etc. The electronic device that can be used independently in the environment has no direct relationship with the performance of the car itself.
NCE1450_NCEP0178F
The functions of the MOS tube in the protection board are: 1. Detect overcharge, 2. Detect over-discharge, 3. Detect over-current during charging, 4. Detect over-current during discharge, 5. Detect over-current during short circuit.
NCE8205B NCE8205 NCE8205i NCE8205E NCE9926.
relevant information
