7B34-03-1_AD1886A Introduction

Systems with a communication interface often require an external application-specific integrated circuit (ASIC) or a dedicated host-controlled microprocessor, but this reduces the flexibility of the design architecture, increases complexity, and takes up space on the circuit board. The newly introduced C2000 F2838x microcontrollers, however, do not rely on external ASICs, thereby reducing the overall solution size and the amount of material used. .

. With the maturity and progress of the process technology and the increase in market demand, more and more companies use advanced processes below 20nm to design and produce ICs and devices, which makes more and more IDMs and foundries eliminate low-efficiency production. fab.

7B34-03-1_AD1886A

AD1865N

So, does this mean that 150mm wafers are gradually withdrawing from the stage of history? The answer is no, there is still a huge market space for 150mm wafers. A large number of 150mm fabs in the industry were closed, and more and more 300mm fabs were launched and gradually achieved mass production.

Flexible VIN broadens application range: The TPS62840 has a wide input voltage range of 1.8VIN-6.5VIN and accepts a variety of chemistries and configurations, such as two lithium-manganese dioxide (2s-LiMnO2) cells in series , single-cell lithium thionyl chloride (1xLiSOCL2) batteries, four- and two-cell alkaline batteries, and lithium polymer batteries (Li-Po).

Due to its wide application, analog chips are less affected by a single downstream boom. From the historical data, from 2000 to 2017, the volatility of analog chips was 1.8%, while the volatility of typical cyclical industry memory over the same period was as high as 6.7%.

Stop pins turn off all switches to reduce EMI or ripple and minimize distortion passed to precision signal chains, measurements, sensors or wireless connected components. The mode pin allows continuous conduction mode (also known as forced pulse width modulation mode) to improve ripple or noise performance and reduce the impact on transmission in sensitive RF applications. .

7B34-03-1_AD1886A

AD22226S

"The new BAW resonator technology is important because TI is integrating it into its silicon products, reducing design time, solution size and component cost," said Philip Solis, research director for connectivity and smartphone semiconductors at IDC.

TPS630701RNMT TPS630702RNMR TPS54218RTER TPS92692PWPR TPS56C230RJER.

However, converting electrical energy into mechanical acoustics while keeping the signal stable and robust within a clean clock is not easy. "TI has been involved in MEMS for years. When asked why no one in the industry has built something like a BAW resonator, Upton said, "It's very difficult to develop.

TPS65400RGZR TPS65400RGZT TPS92515QDGQRQ1 TPS92515QDGQTQ1 TPS560430XFDBVT.

7B34-03-1_AD1886A

The particles in the solid vibrate in an elliptical trajectory, and the long axis of the ellipse is perpendicular to the surface of the solid. . For SAW, also called Rayleighsurface wave, there are both longitudinal waves and transverse waves.

However, the thin film structure needs to be strong enough to be unaffected by subsequent processes. Compared with BAW-SMR, a smaller part of the membrane type is in contact with the underlying substrate, which is not easy to dissipate heat.

relevant information