Standard package 2,000

Packaging standard tape and reel

Active Part Status

Category Integrated Circuit (IC)

Product Family PMIC - Motor Drivers, Controllers

series-

Other names 296-29503-2

DRV8825PWPR-ND

Specification

Motor Type - Stepper Bipolar

Motor Type - AC, DC-

Function Drivers - Fully Integrated, Control and Power Stages

Output configuration half bridge (4)

interface logic

Technology Power MOSFET

Step resolution 1 ~ 1/32

General application

Current - Output 2.5A

Voltage - Power supply 8.2V ~ 45V

Voltage - Load 8.2V ~ 45V

Operating temperature -40°C ~ 150°C (TJ)

Mounting Type Surface Mount Type

Package/Case 28-PowerTSSOP (0.173, 4.40mm Width)

Vendor Device Package 28-HTSSOP

3 Instructions

DRV8825 provides integrated motor driver

Printers, Scanners and Other Automation Solutions

device application. The device has two H-bridges

driver and microstep indexer designed to

Drives a bipolar stepper motor. output driver

block composition. N channel power

MOSFET configured as a full H-bridge to drive

motor windings. The DRV8825 is capable of driving up to 2.5 A from each output (with proper heat).

sink at 24 V and 25°C).

Simple STEP/DIR interface for easy interfacing

to the controller circuit. Mode pins allow configuration

Motor speed in full step to 1/32 step mode. decay

mode is configurable for slow decay, fast decay,

Or you can use mixed decay. low power sleep

Provides a mode for shutting down internal circuits

achieve very low quiescent current consumption. this

Sleep mode can be set using dedicated nSLEEP

pin. Provides internal shutdown function

over current, short circuit, under voltage lockout and

over temperature. Fault conditions are indicated by

nFAULT pin.